What you'll learn
Calibration of Simulated Streamflow
Validation of Simulated flows
Automated Fitted parameters for Catchment
Understand concept of calibration and validation
Write Fitted parameter to SWAT
Data formatting
Advanced GIS Tasks
Requirements
Must Know ArcSWAT
Must have Perfectly simulated ArcSWAT Model
Without calibration at least your simulated data must have R Square 0.5.
Must know GIS very well
Knowledge about Hydrology.
Description
The simulated streamflow needs to calibrate to match the observed flow. That can be possible by getting fitted catchment parameters. Two approaches are available for calibration and validation. One is to use the whole observed at as calibration and second is to split data for validation. Both use almost the same methodology. The objective is to obtain fitted parameters. SWAT CUP does the calibration validation of the whole series. So both scientific concepts are explained theoretically and practically. But the whole data series concept is used by most of the researchers so its explained first, then data split validation concept is explained. So, this is to you which concept you want to use. Writing parameters to the SWAT model is also covered and the calibrated model was run in the course. Mathematics behind the task is a little complex so I suggest downloading a few research papers similar to your study to explain that equations. Such as R Square, NSE, PBIAS, RSR. These all statistics calculated in SWAT Cup.
This is the complete Scientific Course.
Who this course is for:
Water Resource Engineers
Student at WRDM
DAM Engineers
Water Resource Development Scientists
Ph.D Student Working on ArcSWAT Model and GIS
Master Student of Remote Sensing
Civil Engineers
Irrigation Engineers
Earth Science Researchers
Stream flow Investigator
Homepage

https://www.udemy.com/course/swat-cup-calibration-validation-and-write-values-to-arcswat/

Related Downloads :

{related-news}